LM78L Linear Voltage Regulators are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for LM78L Linear Voltage Regulators. LM78L ma Positive Voltage Regulator The TCI LM78LXX family is monolithic fixed voltage regulator integrated circuit. They are suitable for applications that. The LM78LXX series of three terminal positive regulators is available with several fixed output voltages making them useful in a wide range of applications.
|Published (Last):||3 December 2007|
|PDF File Size:||15.35 Mb|
|ePub File Size:||4.35 Mb|
|Price:||Free* [*Free Regsitration Required]|
The wide range of operating frequen- cies gives the power supply designer the flexibility to fine- tune component size, cost, noise and efficiency. Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Features n Input power from 2. Both parts utilize a fixed- frequency, voltage-mode, PWM control architecture and the switching frequency is adjustable from 50kHz to 2MHz by adjusting the value of an external resistor.
LM operate from a low-current 5V bias and can convert. If internal power dissipation becomes too high for the heat sinking provided, the thermal shutdown cir- cuit takes over preventing the IC from overheating. The voltages available allow the LM78LXX to be used in logic systems, instrumentation, HiFi, and other solid state electronic equipment.
Datashret Offset TO Z. Electrical specifications do not apply when operating the device. Home – IC Supply – Link. Electrical specifications do not apply when operating the device outside of its stated operating conditions. The LM employs output over-voltage and under- voltage latch-off. V O Output Voltage. Power up and down. Output over-voltage and under-voltage flag LM Both parts utilize a fixed. They are intended to control currents of 0.
Required to Maintain Line Regulation. Physical Dimensions inches millimeters unless otherwise noted Continued. The adap- tive, non-overlapping MOSFET dayasheet and high-side bootstrap structure helps to further maximize efficiency. Current limit is achieved by monitoring the voltage drop across lj78l on- resistance of the low-side MOSFET, which enhances low duty-cycle operation.
Average Output Voltage Tempco. The LM employs output over-voltage and under.
These regulators can provide local on card regulation, eliminating the distribution problems associated with single point regula- tion. For applications where latch-off is not de.
Typical thermal resistance values for the packages are: The LM and LM are high-speed, synchronous. Recommended minimum load capacitance of 0. The high-side power FET drain voltage can be from 2.
If internal power dissipation becomes too. With adequate heat sinking the regulator can de.
The wide range of operating frequen. Power Good flag, adjustable soft-start and output enable.
Current limiting is included to limit the peak output current to a safe value. Human body model, 1. Safe area pro- tection for the output transistors is provided to limit internal power dissipation.
When used as a zener. Minimum Value of Input Voltage.
LM78L datasheet & applicatoin notes – Datasheet Archive
They are intended to control. For applications where latch-off is not de- sired, the LM can be used. Current limiting is included to.
Power up and down sequencing is achieved with datawheet power-good flag, adjustable soft-start and output enable features. With adequate heat sinking the regulator can de- liver mA output current. Output over-voltage and under-voltage latch-off.